Re: Kantronics KPC-3 + KISS

From: pa3gcu (terhi.victor@logonet.com)
Date: Wed Aug 21 2002 - 21:53:44 EEST

  • Next message: Vivi Kusumo: "error on ax25-tools"

    On Wednesday 21 August 2002 15:37, Andrew Bates wrote:
    > I usually just use a terminal program like 'minicom' to connect to that
    > particular tty port. Then, once connected and set up (9600, 8, n, 1)
    > simply type the following:
    >
    > 1) Hold down 'alt' and type 192 on the keypad, then release 'alt'
    > 2) Hold down 'alt' and type 255 on the keypad, then release 'alt'
    > 3) Hold down 'alt' and type 192 on the keypad, then release 'alt'
    >
    > This is the equivalent of sending C0 FF C0 (in hex) to the TNC. In most
    > cases that is the sequence to tell a TNC to go out of KISS mode. At that
    > point you may have to power cycle your TNC for it to come back up in
    > command line mode.

    Have you tryed 'kissparms -x' ???
    To go out of kiss mode, man kissparms explains the rest.

    >
    > To put most TNCs into KISS from the cmd: prompt simply type 'kiss on' and
    > then power cycle the TNC.
    >
    > Andrew KB0LND
    >
    > > Hello all:
    > > do you know how could i "go in" and "go out" of kiss my KPC-3 under
    > > Linux?
    > >
    > > A lot of thank's.
    > > 

    -- 
Regards Richard
vueslvp.wquwiisyz@outworks.com
http://people.zeelandnet.nl/pa3gcu/

    -
To unsubscribe from this list: send the line "unsubscribe linux-hams" in
the body of a message to dtg@mx.dy.fi
More majordomo info at  http://vger.kernel.org/majordomo-info.html

    This archive was generated by hypermail 2b30 : Wed Aug 21 2002 - 22:06:58 EEST