Re: Kantronics KPC-3 + KISS

From: Andrew Bates (zrfjkg.sgtctftx@wayinternet.com.br)
Date: Wed Aug 21 2002 - 18:37:54 EEST

  • Next message: pa3gcu: "Re: Kantronics KPC-3 + KISS"

    I usually just use a terminal program like 'minicom' to connect to that
    particular tty port. Then, once connected and set up (9600, 8, n, 1) simply
    type the following:

    1) Hold down 'alt' and type 192 on the keypad, then release 'alt'
    2) Hold down 'alt' and type 255 on the keypad, then release 'alt'
    3) Hold down 'alt' and type 192 on the keypad, then release 'alt'

    This is the equivalent of sending C0 FF C0 (in hex) to the TNC. In most
    cases that is the sequence to tell a TNC to go out of KISS mode. At that
    point you may have to power cycle your TNC for it to come back up in command
    line mode.

    To put most TNCs into KISS from the cmd: prompt simply type 'kiss on' and
    then power cycle the TNC.

    Andrew KB0LND

    > Hello all:
    > do you know how could i "go in" and "go out" of kiss my KPC-3 under Linux?
    >
    > A lot of thank's.
    >
    > - --

    -
    To unsubscribe from this list: send the line "unsubscribe linux-hams" in
    the body of a message to vrvfx.lxpd@wachovia.com
    More majordomo info at http://vger.kernel.org/majordomo-info.html

    This archive was generated by hypermail 2b30 : Wed Aug 21 2002 - 18:38:13 EEST