From: Rein Mann (rpz@relay.tunkki.fi)
Date: Mon Jan 22 2001 - 05:53:30 EET
Could anyone help with the following problem:
What I try to achieve: Using tcp/ip (telnet, ping , ftp) straight from Linux.
What I have: RH 6.2, kernel 2.2.14-5 on pentium II 300
ax25 installed as modules, complete with mkiss etc.
With it I run successfully the following software: Xastir (aprs), Linpac (which
uses the ax25 utils files like listen and call)
By sending a kill sig to kissattach I can then run TNOS v 2.3 .
When I try a telnet direct from a linux terminal to a 44.x.x.x address I get
the following msg.
[root@reica /root]# telnet 44.136.138.1
Trying 44.136.138.1...
telnet: Unable to connect to remote host: No route to host
Same happens with 'ping'
The kernel routing table:
[root@reica /root]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
vk4rza.lan * 255.255.255.255 UH 0 0 0 ax0
vk4bvy-2.ampr.o * 255.255.255.255 UH 0 0 0 ax0
reica * 255.255.255.255 UH 0 0 0 eth0
10.0.0.0 * 255.0.0.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
44.0.0.0 vk4rza.lan 255.0.0.0 UG 0 0 0 ax0
44.0.0.0 * 255.0.0.0 U 0 0 0 ax0
the ifconfig cmd:
[root@reica /root]# ifconfig
ax0 Link encap:AMPR AX.25 HWaddr VK4ALJ
inet addr:44.136.141.11 Mask:255.0.0.0
UP RUNNING MTU:255 Metric:1
RX packets:2 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
eth0 Link encap:Ethernet HWaddr 00:40:05:2D:5A:A9
inet addr:10.0.1.1 Bcast:10.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:3 Base address:0x300
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:21 errors:0 dropped:0 overruns:0 frame:0
TX packets:21 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
the host file:
127.0.0.1 localhost
10.0.1.1 reica reica.booyul
10.0.1.2 seffie seffie.booyul
203.17.118.2 mail.ion.com.au
44.136.141.11 vk4alj.ampr.org
203.17.118.7 ftp-proxy.ion.com.au
44.136.138.1 vk4rzb
44.136.141.100 vk4rza vk4rza.lan
44.136.141.29 vk4bvy-2.ampr.org
The packets are going out to tnc and up the spout.
Example: telnet 44.136.138.1
The trace (and the only trace!):
[Mon Jan 22 12:39:47 2001]
Port 2: AX25: VK4ALJ->QST <UI> pid=ARP
ARP: len 30 hwtype AX25 prot 0x800 prlen 4 op REQUEST
sender hwaddr VK4ALJ
target
note: no target address. The same trace for a ping to any address.
Where do I go wrong????? Address Resolution Protocol not doing its job??
Any pointers in the right direction will be gratefully received.
-- r & c mann po box 175 nerang 4211 oubj@cabel212c.bkf.at- To unsubscribe from this list: send the line "unsubscribe linux-hams" in the body of a message to dyuz.iidfowfp@eastgrandforks.net
This archive was generated by hypermail 2b30 : Mon Jan 22 2001 - 06:00:40 EET