Re: Serial communication with TNC2 using minicom

From: Bob Lorenzini (wsavpxme.bjfncissdz@whitehorse.co.uk)
Date: Thu Jun 08 2000 - 17:19:56 EEST

Next message: Wojciech Moczynski: "PLEASE HELP ME...... (fwd)"

Previous message: Richard Adams: "Re: Serial communication with TNC2 using minicom"
In reply to: Stordeur Franck 785966045: "Serial communication with TNC2 using minicom"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Minicom uses /dev/modem to communicate unless you tell it otherwise.
/dev/modem is a symlink to /dev/ttyS0 or 1234 etc. ttyS0 is com1, 1 is
com2 etc. By running minicom -s you can reset the serial post for
that session. Hope this helps.

Bob

Next message: Wojciech Moczynski: "PLEASE HELP ME...... (fwd)"
Previous message: Richard Adams: "Re: Serial communication with TNC2 using minicom"
In reply to: Stordeur Franck 785966045: "Serial communication with TNC2 using minicom"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Thu Jun 08 2000 - 17:22:54 EEST