From: Bryan Curl (rddgvo@bc9.ne.jp)
Date: Fri Apr 07 2000 - 16:01:00 EEST
This works in my KPC-3...
actually.... the command to disable kiss is
kissparms -p <port> -x (dont forget the port as defined in AXPORTS)
use "minicom" program (on a non-kiss tnc) to enable with the standard TNC
command set, INT KISS or whatever MFJ uses. On my KPC-3 I had to do RESET
after changing the Interface type.
----- Original Message -----
From: Richard Adams <terhi.victor@logonet.com>
To: <cizydn@relay.tunkki.fi>
Sent: Friday, April 07, 2000 1:44 AM
Subject: Re: How to Enable/Disable KISS mode in a TNC-2 with Linux?
> On Fri, 07 Apr 2000, Manos Chalaris (SV1DAY) wrote about, How to
Enable/Disable KISS mode in a TNC-2 with Linux?:
> > Hello everybody,
> >
> > I am wondering whether there is a "nice" way to enable/ disable KISS
mode on
> > a TNC-2 with Linux.
> > (I am using an MFJ 1270C, but I think the same is for all the TNC-2 type
> > TNCs...)
> >
> > According to the manual of MFJ, it says the way to enable and disable
KISS
> > mode if you are using the JNOS program (Enable: KISS ON and RESTART and
> > Disable: param <interface_name> 255 from the command prompt of JNOS).
> > It does not mention anything about other software or operating system.
> > Also, there is another method, according to MFJ manual, in order to
disable
> > KISS mode. To remove jumper JMP5, and wait 5 few minutes, then reinstall
> > it.......!!!!!!!!
> >
> > Does anyone knows and nice way, like the one in JNOS?
>
> kissparms -x
>
> Never used it but according to the man page it should work.
>
>
> >
> > Thanks.
> >
> > 73 de SV1DAY
> > Manos
> --
> Regards Richard
> adqkv@com.do
> http://people.zeelandnet.nl/pa3gcu/
>
>
This archive was generated by hypermail 2b29 : Fri Apr 07 2000 - 16:49:20 EEST