From: john Buxton (vcj@cm239-58.liwest.at)
Date: Sun Jan 09 2000 - 00:48:53 EET
Thank you Tomi,
a very "enlightening" reply, however it failed to answer my question.
I had in fact read the message I quoted, I am not in the habit of
quoting unread messages.
It says
"the version of ax25utils is too old for RH6.x"
Good information - however it fails to point out a source tree that will
compile with Rh 6.x.
it then continues with
"for 2.2 kernels, you should download ax25-apps, ax25-tools libax25 from
ftp://ftp.hes.iki.fi/pub/ham/linux/ax25/ and install them as instructed"
wonderful, however this if still not an answer to my question.
the README for fbb says in part
" 1/ Compiling xfbbd and its utilities :
--------------------------------------
- goto fbbsrc/src drectory
- update the variables at the beginning of both Makefile, depending of
your
configuration. This must point to the ax25-utils include and
librairies.
Be sure to use at least the version 2.1.37b of ax25-utils."
Hence the reason for my question.
Jean-Paul says I need at least the version 2.1.37b of ax25-utils. which
is why I am looking fo one that will compile on RH6.x
It appears from the repilies I have seen that others are searching for
the same. Am I to assume that FBB for Linux does not run on RH6.x?
John
-----Original Message-----
From: zbvfofnn@smud.org
[mailto:yfaurz@solcon.nl]On Behalf Of Tomi Manninen
Sent: Sunday, 9 January 2000 5:25
To: 'terhi.victor@logonet.com'
Subject: RE: AX25 and Redhat 6.1
On Sun, 9 Jan 2000, john Buxton wrote:
> I have the same problem with compilation. ax25-utils-2.1.42a.tar.gz
> seems to be the latest version at
> ftp://ftp.hes.iki.fi/pub/ham/linux/ax25/.
>
> Where can I find a version that will compile with RH6.0?
Nowhere. Please _read_ the message you quoted.
> -----Original Message-----
> From: terhi.victor@logonet.com
> [mailto:terhi.victor@logonet.com]On Behalf Of Tapio Sokura
> Sent: Wednesday, 5 January 2000 9:47
> To: lyhiah@off.iptelecom.pl
> Subject: Re: AX25 and Redhat 6.1
>
>
> >Over the last couple of weeks I have been trying to get AX25 going on
> Redhat
> >6.1. I am unable to comple ax25-utils-2.1.42a.tar.gz on the base
> system.
> I get
>
> You are using a too old version of ax25 utils. The system has changed
a
> bit
> for 2.2 kernels, you should download ax25-apps, ax25-tools libax25
from
> ftp://ftp.hes.iki.fi/pub/ham/linux/ax25/ and install them as
instructed.
> The ax25-howto is a bit outdated on the ax25 installation when you are
> using 2.2 kernels.
>
> As for Samba, you should define the interfaces you want Samba to run
on
> in
> your smb.conf (interfaces = ip-addr/mask). If you don't have an
> interfaces
> line, Samba will listen and broadcast on all network interfaces on
your
> machine.
>
> You can also probably configure most of the other packages to only use
> certain interfaces. I think having an IP address is mandatory for a
> network
> interface in 2.2 kernel series. Kernel ipchains would probably be the
> easiest way to disable all ip traffic on your radio interfaces.
>
-- Tomi Manninen Internet: zemwmio.lfsd@apci.net OH2BNS AX.25: pqudvb@lakeviewtech.com KP20ME04 Amprnet: hbiduzea.sjepstiltr@petro-canada.ca
This archive was generated by hypermail 2b29 : Sun Jan 09 2000 - 01:21:05 EET