I have problem to make a regular TCPIP call over AX25.
If I try to telnet or ftp to remote node, on the monitor
I see that my node is sending:
Port 1: AX25: OK1FWG-15->QST <UI> pid=ARP
source:
destination:
The addresses of source and destination are correct, but how
to replace the QST of my default node? I had setup it via
axparms -route etc. I can list the route table but on every
attempt it sends out the above mentioned frame with the QST.
73, Willi, OK1FWG