Now I have a couple of questions about the practical use of this setup.
My goal is to provide axip links (digi, not netrom) for our local DX
cluster (who access me via RF on the pi card port) to link to remote
systems. (I previously had all this working with TNOS as the gateway;
now I'm trying to transfer the functionality into kernel AX.25).
Apart from defining the "mycall" in ax25ipd.conf and setting up the
routes to the remote gateways, is there anything else I need to do? In
particular, do I need to put an entry in axports (or any of the other
ax25 config files) for W8APR-7 or /dev/pi0a? Or, am I finished with
what I show below in ax25ipd?
And, when I had the ax25ipd logging set at 2 or 3, I was seeing an
error message along the lines of "I am destination" at frequent
intervals. I believe this was caused by stations connecting to me via
the PI card and using other services than ax25ipd. Is it correct that
this message is harmless and I can ignore it?
Thanks for any pointers on this.
73,
John N8UR
vsczq@univ-lille2.fr
- --------------
# ax25ipd.conf
socket ip
mode digi
mycall W8APR-7
device /dev/pi0a # this device is a pty created by net2kiss
speed 9600
loglevel 1
route DAYIND 206.31.50.198
route DAYYOU 198.228.192.70