I think from reading all that has been written, that you need to make sure
you have included all the nessacery options in your /linux/.config
You did mention that there were modules that wernt being loaded, so i
presume from this that you did not chose the correct options.
The options underneath are detailed with =y, if you use modules it will be
=m ( i think).
CONFIG_EXPERIMENTAL=y <- if you say no here some options WILL not appeer.
CONFIG_AX25=y
CONFIG_NETROM=y
a little futher down in make config
CONFIG_NET_RADIO=y
CONFIG_MKISS=y <--- this is what i think is wrong....
> >
> > Anyway, any help would be appreciated. Believe me when I say I have combed the
> > AX25 FAQ, HOW_TO's, digiboard's own site and readme's, recompiled the kernel and
> > AX25 utilities umpteen times before I even approached this list.
> I read all this too, may be I have too new kernel :) Ok I will try
> kernel 2.0.27 now
>
>
> --
> Jim Smelyansky, AKA Vadim Popkov, AKA Proglot, voice: +380-6264-58215
> mailto://jdjlopq.qbsmchyo@borenius.com, JS476-RIPE, FIDO: 2:4651/1.0
> Ampr: terhi.victor@logonet.com http://www.axis.donetsk.ua/~jim
>
-- Regards Richard, 73. AX25 pa3gcu@pi8mid.#zld.nld.eu smtp qsk@amfirst.org inet mwdc@sth.ac.at