As i probably before have asked you i appologies for my week remembering HI.
I am testing with my PTC-II and the FBB7.00f for DOS.
I need to have the callsign OZ3BOE for U/VHF and the OZ4SCA for HF.
I have the OZ3BOE in my INIT.SRV as you can see in the attachment.
I have the OZ4SCA in the bottom of the PORT.SYS. Can also be seen in the
attachment.
When I call on HF the callsign used is OZ4SCA. If another BBS calls me on HF
its the OZ3BOE callsign that is in use. Should have been OZ4SCA.
Can i avoid that, and if so how can I do it ??.
Sincerelly
Here the init.srv:
^^^^^^^^^^^^^^^^^^^
# FBB7.00f
#
###########################
# INIT.SRV for FBB 7.00f #
# for LA6CU BBS by OZ3BOE #
###########################
#
# Set-up file
#
#
# Callsign and H-route of BBS, without SSID
OZ3BOE.OEL.JYN.DNK.EU
#
Here the port.sys:
^^^^^^^^^^^^^^^^^^^
# FBB7.00
# File for programming of channels and TNCs.
#
# Ports : How many ports (COM1, COM2, Etc...)
# TNCs : How many TNCs and modems in use. With multiplexer
# there can be up to 4 TNCs per port.
#
#Ports TNCs
1 2
#
#Com Interface Address (device) Baud
1 1 3F8 19200
#
#
#TNC NbCh Com MultCh Pacln Maxfr NbFwd MxBloc M/P-Fwd Mode Freq
1 1 1 0 250 2 1 10 10/60 HU PACTOR
2 10 1 1 250 2 1 10 10/60 HULWY VHF-1200
#
# Special callsigns and modes for some channels.
#
#TNC Nbs Callsign-SSID Mode
1 1 OZ4SCA B
#
# End of file.
#
73, Erik /OZ4KK
Sysop OZ3BOE - V/UHF and OZ4SCA HF- BBS's.